7.3.4.9 no spanning-tree mst
Description
With this command, you reset the various properties of the Multiple Spanning Tree function to
the default value.
The default values are as follows:
Parameter Default value
cost
● 200000 for physical interfaces
● 199999 for port channels
port-priority 128
disable The Multiple Spanning Tree function is enabled on the interface
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no spanning-tree mst<instance-id(1-64)>{cost|port-priority|disable}
The parameters have the following meaning:
Parameter Description Range of values / note
instance-id Number of the addressed instance 1 ... 64
cost Keyword for the costs of the port for cal‐
culating the lowest-cost path.
-
port-priority Keyword for the priority of the interface -
disable Enables the interface for multiple span‐
ning tree.
-
Note
Configure multiple properties
With each call of the command, you can configure precisely one property.
If you want to configure several properties, call the command several times.
Result
The selected setting is reset to the default value.
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
332 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
