Syntax
Call up the command with the following parameters:
show wlan ssid-table <wlan 0/X>
The parameter has the following meaning:
Parameter Description Range of values / note
wlan 0/X WLAN interface Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The table with the SSIDs configured on the client and their status is displayed.
See also
wlan ssid-table edit (client) (Page 248)
7.1.1.19 show wlan vap (access point)
Description
This command shows the configuration of the VAP interface.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan vap <vapX 0/Y>
The parameter has the following meaning:
Parameter Description Range of values / note
vapX 0/Y VAP interface Enter a valid interface.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
200 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
