11.3.5.5 no vap security encryption (access point)
Description
With this command, you disable encryption with a fixed (unchanging) WEP key. This setting
is activated as default. You can only enable or disable encryption if you have selected "Open
System" for authentication.
Note
This command is available only in access point mode.
Requirement
● The type of authentication is "open-system".
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call the command without parameter assignment:
no vap security encryption
Result
The encryption is disabled.
Further notes
You display the settings with the show wlan security <vapX 0/Y> command.
You enable the encryption with the vap security encryption command.
See also
vap security encryption (access point) (Page 529)
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
530 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
