4.1.11.5 lldp
Description
With this command, you enable the sending and receipt of LLDP packets on the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
lldp{transmit|receive}
The parameters have the following meaning:
Parameters Description
transmit the sending of LLDP packets is enabled
receive the receipt of LLDP packets is enabled
At system start or when using the restart command with the option memoryor factory,
the following defaults apply:
● Sending and receipt of LLDP packets are enabled.
Note
Enabling both options
When you call this command, you can only select one option.
If you want to enable both options, call up the command again.
Result
The setting is configured.
Further notes
You disable the sending or receipt of LLDP packets with the no lldp command.
You display the status of LLDP with the show lldp status command.
Configuration
4.1 System
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
78 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
