Result
The entry for the start and end of daylight saving time was created.
Further notes
You display the settings for the daylight saving time changeover with the show dst info
command.
6.1.2.5 no time dst
Description
With this command you delete the entry for the start and end of daylight saving time with the
specified name. If you do not specify a name as the parameter, all entries are deleted.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no time dst [<name(16)>]
The parameter has the following meaning:
Parameter Description Range of values / note
name Name of the entry maximum 16 characters
Result
An entry or the entries for the start and end of daylight saving time was/were deleted.
Further notes
You display the settings for the daylight saving time changeover with the show dst info
command.
6.2 NTP client
This section describes commands relevant for configuration of the NTP client.
System time
6.2 NTP client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
172 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
