Further notes
You display the setting with the show wlan security ap-radius-authenticator
command.
See also
show wlan security ap-radius-authenticator (Access Point) (Page 496)
11.3.2.11 wlan security context (Client)
Description
With this command, you create a new security context and change to the security context
configuration mode.
Note
This command is only available in the client mode.
Requirement
You are in the WLAN configuration mode.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
wlan security context <ID (1-8)>
The parameter has the following meaning:
Parameters Description Range of values / note
ID ID of the security context 1...8
Result
The security context is created,
You are in the security context configuration mode.
The command prompt is as follows:
cli (config-wlan-context-$)#
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 509
To Next Page
Loading...
Need help?
General
