Some commands are available only in the "access point" or in the "client" mode. In these cases,
the titles have the term access point or client added to them.
Example: wlan mode
● wlan mode (access point): The function can only be used with access points.
● wlan mode (client): The function can only be used with clients.
11.3.1 The "show" commands
This section describes commands with which you display various settings.
11.3.1.1 show wlan security
Description
This command shows the security settings of the SCALANCE W700 device, for example the
encryption method.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan security <wlan 0/X | vapX 0/Y> [context <Id (1-8)>]
The parameters have the following meaning:
Parameter Description Range of values / note
wlan 0/X WLAN interface
Only available in client mode
Enter a valid interface.
vapX 0/Y VAP interface
Only available in Access Point mode
Enter a valid interface.
context Keyword for a security context -
Id Enter a valid security context ID. Available only in client mode
1...8
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 495
To Next Page
Loading...
Need help?
General
