Siemens SCALANCE W770 Series User Manual

Further notes
You shut down the interface with the shutdown complete command.
You can display the status of this function and other information with the show
interfacescommand.
4.2 Load and Save
This section describes commands for displaying, copying, saving and downloading files for
the device.
Note
Note that during the installation of a previous version, the configuration data can be lost. In
this case, the device starts up with the factory configuration settings after the firmware has
been installed.
Overview of the file types
Table 4-1 HTTP
File type Description Down‐
load
Save Delete
Config Start configuration X X --
ConfigPack Detailed configuration information. for example,
start configuration, users, certificates, favorites, firm‐
ware of the device (if saved as well).
For more detailed information on creating and using
the ConfigPack incl. firmware, refer to the section
"Maintenance".
X X --
CountryList The zip file contains the country list as a csv and as
a pdf file.
-- X --
Debug This file contains information for Siemens Support. -- X X
EDS Electronic Data Sheet (EDS)
Electronic data sheets for describing devices in the
EtherNet/IP mode
-- X --
Firmware Loading firmware updates X X --
GSDML Information on the device properties (PROFINET) -- X --
HTTPS Cert HTTPS certificate
Maximum file size: 8192 bits
X X X
LogFile File with entries from the event log table -- X --
MIB Private MSPS MIB file "Scalance_w_msps.mib" -- X --
RunningCLI This file contains an overview of the current config‐
uration in the form of CLI commands. You can down‐
load the text file. The file is not intended to be uploa‐
ded again unchanged.
-- X --
Configuration
4.2 Load and Save
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
82 Configuration Manual, 09/2017, C79000-G8976-C324-08

Siemens SCALANCE W770 Series Specifications

General

Brand	Siemens
Model	SCALANCE W770 Series
Category	Wireless Access Point
Language	English