12.2 Syslog client
With the commands in this section, the following settings are configured:
● Transfer of the messages to the Syslog server
● Local buffering and storage of messages
● Receipt and forwarding of messages from other devices (relay mode)
12.2.1 The "show" commands
This section describes commands with which you display various settings.
12.2.1.1 show events syslogserver
Description
This command shows the entries of the configured Syslog server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show events syslogserver
Result
The entries of the configured Syslog server are displayed.
12.2.2 Commands in the Events configuration mode
This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the events command to change to this mode.
Diagnostics
12.2 Syslog client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 603
To Next Page
Loading...
Need help?
General
