Result
The following WDS settings are displayed:
● Admin status
● Connection over
● Partner ID type
● Partner MAC
● Partner WDS ID
7.1.1.21 show wlan wds-list (access point)
Description
This command shows the WDS partners connected to the WLAN interface.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan wds-list <wlan 0/X>
The parameter has the following meaning:
Parameter Description Range of values / note
wlan 0/X WLAN interface Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The WDS partners of the WLAN interface are displayed.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
202 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
