Further notes
You exit the security context configuration mode with the command end or exit.
You delete a security context with the no wlan security context command.
You display the setting with the show wlan security command.
11.3.2.12 no wlan security context (Client)
Description
With this command, you delete a security context.
Note
This command is only available in the client mode.
Note
The security context 1 cannot be deleted.
Requirement
You are in the WLAN configuration mode.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
no wlan security context <ID (1-8)>
The parameter has the following meaning:
Parameters Description Range of values / note
ID ID of the security context 1...8
Result
The security context is deleted,
Further notes
You create a security context and change to the security context configuration mode with the
command wlan security context.
You display the setting with the show wlan security command.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
510 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
