The parameters have the following meaning:
Parameter Description Range of values / note
showfiles Shows the available files -
filetype Keyword for a file type to be loaded -
filetype Name of the file type max. 100 characters
Result
The file types are displayed or the file is copied.
Further notes
You configure the name of the file with the tftp filename command.
With the "show loadsave files" command, you can display the file types.
4.2.5.5 tftp server
Description
With this command, you configure the access to a TFTP server.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
tftp server {ipv4 <ucast-addr> | fqdn-name <FQDN> | ipv6 <ip6_addr>}
[port <tcp port(1-65535)>]
The parameters have the following meaning:
Parameter Description Range of values / note
ipv4 Keyword for an IPv4 address -
ipv4-address Value for an IPv4 unicast address Enter a valid IPv4 unicast address.
fqdn-name Keyword for a domain name -
FQDN Domain name (Fully Qualified Domain
Name)
Maximum 100 characters
ipv6 Keyword for an IPv6 address -
ip6_addr Value for an IPv6 unicast address Enter a valid IPv6 unicast address.
Configuration
4.2 Load and Save
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
92 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
