Result
The IP address is assigned to the VLAN interface.
Note
Effectiveness of the command
The command is effective immediately.
If you configure the interface via which you access the device, the connection will be lost!
Further notes
You delete the settings with the no ip address command.
You display this setting and other information with the show ip interface command.
8.1.3.2 no ip address
Description
With this command, you delete the assignment of an IP address to a VLAN interface.
Requirement
You are in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ip address [{ <ucast_addr>|dhcp}]
The parameter has the following meaning:
Parameter Description Range of values / note
ucast_addr IP Address of the VLAN interface that will be
deleted
enter a valid IP address
dhcp Specify this parameter if you want to cancel
the obtaining of the IP address from a DHCP
server.
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Network protocols
8.1 IPv4 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
356 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
