(
[<NextHop>] {vlan <vlan-id (1-4094)> [<administrative distance>]
[unicast]|
[<administrative
distance>]
[unicast]
|
[<interface-type>
<interface-id>]
[<administrative distance>] [unicast]
})
The parameters have the following meaning:
Parameter Description Range of values / note
prefix len Number of bits belonging to the prefix
(from left to right)
1 ... 128 bits
NextHop IPv6 address of the gateway to which the selected addresses will be
forwarded.
Enter a valid IPv6 address.
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
administrativ
e distance
Value for the administrative distance 1 ... 254
Default: 1
unicast Addressing mode unicast -
interface-
type
Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Result
The entry is deleted.
Further notes
You configure a static entry in the IPv6 routing table with the ipv6 route command.
You display the IPv6 routing table with the show ipv6 route command.
8.2.4 Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Network protocols
8.2 IPv6 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 369
To Next Page
Loading...
Need help?
General
