EasyManuals Logo

Siemens SCALANCE W770 Series User Manual

Siemens SCALANCE W770 Series
616 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #532 background imageLoading...
Page #532 background image
11.3.5.7 vap security wpa-psk-passphrase (access point)
Description
With this command, you store the WPA(2) key that is used in WPA-PSK and WPA2-PSK
authentication.
Note
The key can be 8 to 63 ASCII characters or exactly 64 hexadecimal characters long. It should
be selected so that is complex for example consisting of random numbers, letters (upper-/
lowercase), have few repetitions and special characters. Do not use known names, words or
terms that could be guessed. If a SCALANCE W700 device is lost or if the key becomes known,
the key should be changed on all SCALANCE W700 devices to maintain security.
Note
This command is available only in access point mode.
Requirement
WPA-PSK, WPA2-PSK or WPA(2)-PSK auto is set for the type of authentication.
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call up the command with the following parameters:
vap security wpa-psk-passphrase <string>
The parameter has the following meaning:
Parameter Description Range of values / note
string WPA(2) key. 8....63ASCII or exactly 64 hex
Result
A WPA(2) key is specified.
Further notes
You display the settings with the show wlan security <vapX 0/Y> command.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
532 Configuration Manual, 09/2017, C79000-G8976-C324-08

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE W770 Series and is the answer not in the manual?

Siemens SCALANCE W770 Series Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE W770 Series
CategoryWireless Access Point
LanguageEnglish

Related product manuals