The parameter has the following meaning:
Parameter Description Range of values / note
prefix IPv6 address of the neighbor node Enter a valid IPv6 address.
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
interface-
type
Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
MAC ADDRESS Link layer address (MAC address) of the neighbor node xx:xx:xx:xx:xx:xx
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Result
The entry is deleted.
Further notes
You configure an entry with the no ipv6 neighbor command.
You display the IPv6 neighbor table with the show ipv6 neighbors command.
8.2.3.3 ipv6 path mtu
Description
With this command, you configure maximum packet size (MTU). The setting is only effective
if PMTU Discovery is enabled.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ipv6 path mtu <prefix addr> <mtu>
Network protocols
8.2 IPv6 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
364 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
