Requirement
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp client request {dns-server-address | domain-name | sntp-
server-address | option <code (1-100)>}
The parameters have the following meaning:
Parameter Description Range of values / note
dns-server-
address
IPv6 address of the DNS server -
domain-name Domain name -
sntp-server-
address
IPv6 address of the SNTP server -
option Keyword for the option code -
code Number of the DHCPV6 option Enter the required number.
1 ... 200
Result
The setting is configured.
Further notes
You remove the request with the no ipv6 dhcp client request command.
8.4.3.2 no ipv6 dhcp client request
Description
With this command, you remove the request for the configuration parameter.
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
Network protocols
8.4 DHCPv6 client (IPv6)
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
386 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
