Parameter Description Range of values / note
stats Shows the number of incoming and outgoing
packets for each path of the interface
-
hello-time Shows the intervals at which the root switch
sends its "Hello" message to the other
switches
-
detail Shows detailed information about the selec‐
ted interface
-
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The settings are displayed.
Further notes
You display the general settings for the Spanning Tree Protocol with the show spanning-
tree command.
7.3.1.10 show spanning-tree root
Description
This command shows the settings of the root bridge for the spanning tree function.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show spanning-tree root
[{address|cost|forward-time|id|max-age|port|priority|detail}]
The parameters have the following meaning:
Parameter Description
address Shows the MAC address of the root bridge
cost Shows the costs of the connection to the root bridge.
forward-time Shows the time that the bridge is in the listening mode when changing from
the blocking mode to the learning mode
id Shows the ID of the root bridge
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
308 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
