In the Global Configuration mode, enter the interface wlan 0/X command to change to
this mode.
● If you exit the WLAN Interface Configuration mode with the exit command, you return to
the Global Configuration mode.
● If you exit the WLAN Interface Configuration mode with the end command, you return to
the Privileged EXEC mode.
11.3.3.1 wlan security edit key
Description
With this command, you add a WEP or AES key to the key table. You can choose between
several key lengths.
● 5 or 13 ASCII or 10 or 26 hexadecimal characters specify a weaker key (40/104 bits).
● 16 ASCII or 32 hexadecimal characters, on the other hand, define a strong key (128 bits).
Note
iPCF or iPCF-MC mode activated
If you want encryption with AES in iPCF or iPCF-MC mode, only keys with a 128 bit key length
are supported.
Requirement
You are in the Interface configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan security edit key <key index(1-4)> <key>
The parameters have the following meaning:
Parameter Description Range of values / note
key index Index of the key table 1...4
key Key Enter the WEP or AES key.
Result
The WEP or AES key is inserted in the key table.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
512 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
