The parameters have the following meaning:
Parameter Description Range of values / note
ipv4 Keyword for an IPv4 address -
ipv4-address Value for an IPv4 unicast address Enter a valid IPv4 unicast address.
fqdn-name Keyword for a domain name -
FQDN Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
ipv6 Keyword for an IPv6 address -
ip6_addr Value for an IPv6 unicast address Enter a valid IPv6 unicast address.
port Keyword for the port of the server via
which the SFTP connection runs
-
tcp port Number of the port 1 … 65535
user Keyword for user -
username User name for access to the SFTP serv‐
er
Enter a valid user name.
This assumes that a user with the
corresponding rights has been cre‐
ated on the SFTP server.
Refer to the information in the sec‐
tion "CLI command prompt
(Page 27)".
password Keyword for a password -
password Password of the user Enter the password for the user.
Refer to the information in the sec‐
tion "CLI command prompt
(Page 27)".
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The settings for the access to the selected SFTP server are configured.
4.2.5.10 password
Description
With this command, you activate and configure the password for encrypted certificates.
User, server or HTTPS certificates can exist as PKCS#12 certificates (.p12 and .pfx) and PEM
certificates (.pem).
Note
User and server certificate in one file
If the user and the server certificate are located in the same file, load this file on the device as
the user certificate and as the server certificate.
Configuration
4.2 Load and Save
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
96 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
