8.7 SMTP client
This section describes commands of the Simple Mail Transfer Protocol (SMTP).
8.7.1 The "show" commands
This section describes commands with which you display various settings.
8.7.1.1 show events smtp-server
Description
This command shows the configured SMTP servers.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show events smtp-server
Result
The configured SMTP servers are displayed.
8.7.1.2 show events sender email
Description
This command shows the configured e-mail sender address.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Network protocols
8.7 SMTP client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
436 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
