8.7.2.2 no smtp-server
Description
With this command, you delete an SMTP server entry.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
no smtp-server { ipv4 <ucast_addr> | fqdn-name <FQDN)> | ipv6
<ip6_addr>}
The parameters have the following meaning:
Parameter Description Note on the range if values
ipv4 Keyword for an IPv4 address -
ucast_addr IPv4 address of the SMTP server Enter a valid IPv4 unicast address.
fqdn-name Keyword for a domain name -
FQDN Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
ipv6 Keyword for an IPv6 address -
ip6_addr IPv6 address of the SMTP server Enter a valid IPv6 address.
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 29)".
Result
The SMTP server entry is deleted.
Further notes
You configure an SMTP server entry with the smtp-server command.
8.7.2.3 sender mail-address
Description
With this command, you configure the e-mail name of the sender.
Network protocols
8.7 SMTP client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 439
To Next Page
Loading...
Need help?
General
