To Next Page

To Previous Page

The parameter has the following meaning:

Parameter Description Range of values / note

prefix Link local address Specify a valid link local address.

fe80::XXXX:XXXX:XXXX:XXXX

For information on names of addresses and interfaces, refer to the section "Interface identifiers

and addresses (Page 29)".

Result

The link local address is assigned to the interface.

Further notes

You delete the link local address with the no ipv6 address link-local command.

You display this setting and other information with the show ipv6 interface command.

8.2.4.8 no ipv6 address link-local

Description

With this command, you delete the link local address.

Requirement

● IPv6 is activated

● The interface is an IP interface.

● You are in the Interface configuration mode

The command prompt is as follows:

cli(config-if-$$)#

Syntax

Call up the command with the following parameters:

no ipv6 address <prefix> link-local

The parameter has the following meaning:

Parameter Description Range of values / note

prefix Link local address Specify a valid link local address.

fe80::xxxx:xxxx:xxxx:xxxx

For information on names of addresses and interfaces, refer to the section "Interface identifiers

and addresses (Page 29)".

Network protocols

8.2 IPv6 protocol

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

376 Configuration Manual, 09/2017, C79000-G8976-C324-08

Siemens SCALANCE W770 Series User Manual

Questions and Answers: