Result
The assignment is removed.
Further notes
You configure the assignment with the wlan iprp interface command.
5.7.3.3 wlan iprp network
Description
With this command, you specify the VLAN assignment for PRP A and PRP B.
Requirement
You are in the WLAN iPRP configuration mode.
The command prompt is as follows:
cli (config-wlan-iprp-$)#
Syntax
Call up the command with the following parameters:
wlan iprp network {A | B} <vlan-id (1-4094)>
The parameters have the following meaning:
Parameter Description Range of values / note
network PRP Network A: PRP A
B: PRP B
vlan-id Number of the addressed VLAN 1 ... 4094
Result
The VLAN assignment is configured.
Further notes
You display this setting and other information with the show wlan iprp information
command.
You delete the assignment with the no wlan iprp network command.
Functions specific to SCALANCE
5.7 iPRP
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 151
To Next Page
Loading...
Need help?
General
