Syntax
Call up the command with the following parameters:
interface{vlan<vlan-id(1-4094)>
<interface-type><interface-id>}
The parameters have the following meaning:
Parameter Description Range of values / note
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 … 4094
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
Result
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
The placeholder $$$ is replaced by the following name of the interface:
Type of interface Command prompt
wlan cli(config-if-wlan-0-$)#
wds cli(config-if-wds$-0-$)#
vap cli(config-if-vap$-0-$)#
vlan cli(config-if-vlan-$)#
fast-ethernet cli(config-if-Fa-0-$)#
The placeholders $ or $-$ denote the numbering of the interface.
For the value ranges for the VLAN logical interface, refer to the upper table. You can only call
up interfaces that you created with the vlan command.
The ranges of values from the physical interfaces depend on the hardware configuration.
Further notes
You exit the Interface Configuration mode with the end or exit command.
You delete a logical interface with the no interface command.
You display the status and the configuration of the interfaces with the show interfaces
command.
4.1.10.6 no interface
Description
With this command, you delete a logical interface.
Configuration
4.1 System
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 69
To Next Page
Loading...
Need help?
General
