Result
The latitude coordinate is created.
4.1.10.3 coordinates longitude
Description
With this command, you enter a longitude coordinate.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
coordinates longitude <longitude>
The parameter has the following meaning:
Parameter Description Range of values / note
longitude Input box for the longitude coordinate max. 32 characters
To use spaces in the entry, enter
the longitude coordinate in quotes:
coordinates longitude
"123 456"
Result
The longitude coordinate is created.
4.1.10.4 ethernetip
Description
With this command, you set whether EtherNet/IP will be enabled or disabled after the next
device restart.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
Configuration
4.1 System
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 67
To Next Page
Loading...
