8.2.4.4 no ipv6 address autoconfig
Description
With this command you disable stateless autoconfiguration of the IPv6 address via NDP
(Neighbor Discovery Protocol).
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 address autoconfig
Result
Stateless autoconfiguration is enabled.
Further notes
You enable the setting with the ipv6 address autoconfig command.
You show the setting with the show ipv6 dhcp interface command.
You can display the statistics of the DHCPv6 client with the show ipv6 dhcp client
statistics command.
8.2.4.5 ipv6 address dhcp
Description
With this command, you specify whether the DHCPv6 client obtains the IPv6 address from the
DHCPv6 server.
Network protocols
8.2 IPv6 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 373
To Next Page
Loading...
Need help?
General
