Parameter Description Range of values / note
count Number of packets -
size Keyword for the size of the packets to
be transferred
-
value Packet size 0 … 2080 bytes
Default: 100
anycast Addressing mode anycast -
source Keyword for the sender interface
● VLAN
● source_prefix
-
vlan Keyword for a VLAN connection -
id Number of the addressed VLAN 1 ... 4094
source_prefix Prefix of the sender -
timeout Response wait time
If this time expires, the request is re‐
ported as "timed out".
-
value Time until timeout 1 ... 100 s
Default: 1
Result
The messages relating to the response of the called node are displayed.
4.1.10 Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
4.1.10.1 coordinates height
Description
With this command, you enter a height coordinate.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
Configuration
4.1 System
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 65
To Next Page
Loading...
Need help?
General
