7.2.1.4 show mac-address-table count
Description
With this command, you show the number of MAC addresses for all or a selected VLAN.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show mac-address-table count[vlan<vlan-id(1-4094)>]
The parameters have the following meaning:
Parameter Description Range of values / note
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
If you do not select any parameter from the parameter list, the total number of entries is
displayed for all VLANs.
Result
The number of MAC addresses for the selected VLAN is displayed.
7.2.1.5 show vlan
Description
This command shows the specific information for all or a selected VLAN.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
Network structures
7.2 VLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
282 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
