Siemens SCALANCE W770 Series User Manual

Further notes
You disable the setting with the no firmeware-in-configpack command.
4.2.5.13 no firmeware-in-configpack
Description
With this command you take firmware file out of the ConfigPack file.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call the command without parameter assignment:
no firmeware-in-configpack
Result
The function is disabled.
Further notes
You enable the function with the firmeware-in-configpack command.
4.3 Reset and Defaults
This section describes commands for restarting the device and for restoring the original
configuration.
4.3.1 restart
Description
With this command, you restart the device.
Configuration
4.3 Reset and Defaults
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 99

Siemens SCALANCE W770 Series Specifications

General

Brand	Siemens
Model	SCALANCE W770 Series
Category	Wireless Access Point
Language	English