Further notes
You can display the setting of this function and other information with the show ip http
server statuscommand.
You deactivate HTTP on the device with the no ip http command.
8.8.2.2 no ip http
Description
With this command, you disable the access via HTTP. You can only access the WBM of the
device using HTTPS.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip http
Result
Access to the WBM is now only possible with HTTPS.
Further notes
You can display the setting of this function and other information with the show ip http
server statuscommand.
You enable HTTP with the ip http command.
8.9 HTTPS server
This section describes commands of the Hypertext Transfer Protocol Secure (HTTPS).
8.9.1 The "show" commands
This section describes commands with which you display various settings.
Network protocols
8.9 HTTPS server
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
444 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
