Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ports
(
[<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]
)
[
untagged<interface-type> <0/a-b,0/c,...>
(
[<interface-type><0/a-b,0/c,...>] [all]
)
]
[
forbidden<interface-type><0/a-b,0/c,...>
[<interface-type><0/a-b,0/c,...>]
]
[name<vlan-name>]
The parameters have the following meaning:
Parameter Description Range of values / note
interface-type Type or speed of the interface
● fastethernet
/a-b,0/c,... Port no. of the interface Enter a valid interface name
/a-b,0/c,... Port no. of the interface Enter a valid interface name
untagged Keyword for interfaces or ports that transfer data
packets without VLAN marking
-
all Specifies that all interfaces or ports are set to
"untagged"
-
forbidden Keyword for forbidden interfaces or ports -
name Keyword for the name assignment -
vlan-name Name of the VLAN max. 32 characters
Result
The settings are enabled.
Further notes
You display details of the function with the show vlan command.
You reset the settings with the no ports command.
Network structures
7.2 VLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 299
To Next Page
Loading...
Need help?
General
