| wds | dfs | wlan-general | ipcf-cycle-time | ipcf-poll-size |all}
{logtable | syslog | email | trap | faults | all}
The parameters have the following meaning:
Parameter Description
cold-warmstart Message if there is cold or warm restart
linkchange Message when there is a status change on a physical interface
authentication-failure Message if there is an incorrect login
power-change Message when there is a status change in the power supply
faultstate-change Message when there is a status change in the error monitoring
stp-change Message when there is a change in the Spanning Tree
client-wlan-auth In client mode only:
Message for successful or failed WLAN authentication attempts (only in client mode)
overlap-ap Only in access point mode:
Message there is an entry in the "Overlap AP" list.
wds Only in access point mode:
Message when there is a change in the connection status of a WDS link
dfs Only in access point mode:
Message when a radar signal was received or the DFS scan was started or stopped.
wlan-general Only in access point mode:
Message when the channel bandwidth has changed.
ipcf-cycle-time Only available when the KEY-PLUG is inserted and only in Access Point mode
Message if too many clients are logged on for the set iPCF cycle time or if some clients
were not reached in one cycle
ipcf-poll-size Only available when the KEY-PLUG is inserted.
Message when the PROFINET data size is too large for transfer.
all All messages
logtable Client that processes the logbook entries
syslog Client that sends the messages to the log server
email Client that sends the e-mails
trap Client that sends the SNMP traps
faults The device triggers an error. The error LED lights up.
all All clients at once
Result
The setting deciding which messages of the device should not be stored or sent is configured.
Further notes
You display the status of the events and the clients with the show events config command.
You configure which of the various message types of the device will be stored or forwarded
with the event config command.
Diagnostics
12.1 Diagnostics
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 595
To Next Page
Loading...
Need help?
General
