Phaser 7500 Printer Service Manual 3-25
Error Messages and Codes
This operation forcedly restores the HDD to the partition status at factory
settings.
a. HDD formatting is performed by turning the power On while pressing the
Energy Saver button, Up button and Down button at the same time.
4. If the problem persists, replace the HDD and perform the same operation
where the error occurred.
5. If the problem persists, replace the Image Processor Board (REP 35.1,
page 8-220) and perform the same operation where the error occurred.
6. Return NVM that was set in Step 1 to "1".
If the system is not restored after the Image Processor Board has been replaced,
reinstall the original Image Processor Board.
To Next Page
Loading...
