Alcatel-Lucent OmniAccess 5740 - Page 258

802.1X Port-Based Authentication
Left running head:
Chapter name (automatic)
232
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE TIME-OUT FOR QUIET PERIOD
EXAMPLE
ALU(config-if switchport5/0)# dot1x timeout quiet-period 50
ALU(config-if switchport5/0)# no dot1x timeout quiet-period
T
O CONFIGURE SWITCH-TO-CLIENT RETRANSMISSION TIME
EXAMPLE
ALU(config-if switchport5/0)# dot1x timeout tx-period 60
ALU(config-if switchport5/0)# no dot1x timeout tx-period
Command (in ICM) Description
dot1x timeout quiet-period
<1-3600>
This command sets the number of
seconds that the OmniAccess 5740 USG
remains in the quiet state following a failed
authentication exchange with the client.
no dot1x timeout quiet-period
[<1-3600>]
This command sets the quiet period to its
default.
The default is 60 seconds.
Command (in ICM) Description
dot1x timeout tx-period <1-
3600>
This command sets the number of
seconds that the OmniAccess 5740 USG
waits for a response to an EAP-request/
identity frame from the client before
retransmitting the request.
no dot1x timeout tx-period
[<1-3600>]
This command sets the tx-period to its
default.
The default is 30 seconds.