Alcatel-Lucent OmniAccess 5740 - Class Map

802.1X Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
233
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO CONFIGURE SWITCH-TO-CLIENT RETRANSMISSION TIME FOR EAP-REQUEST FRAMES
EXAMPLE
ALU(config-if switchport5/0)# dot1x timeout supp-timeout 40
ALU(config-if switchport5/0)# no dot1x timeout supp-timeout
T
O CONFIGURE SWITCH-TO-CLIENT FRAME RETRANSMISSION NUMBER
EXAMPLE
ALU(config-if switchport5/0)# dot1x max-request 3
ALU(config-if switchport5/0)# no dot1x max-request
Command (in ICM) Description
dot1x timeout supp-timeout
<1-65535>
This command sets the switch-to-client
retransmission time for the EAP-request
frame.
no dot1x timeout supp-timeout
[<1-65535>]
This command sets the supp-timeout to its
default.
The default is 30 seconds.
Command (in ICM) Description
dot1x max-request <1-10> This command sets the number of times
that the switch sends an EAP-request/
identity frame to the client (assuming no
response is received) before restarting the
authentication process.
no dot1x max-request [<1-10>] This command sets the max-request to its
default.
The default is 2.