T1E1 Line Card
Left running head:
Chapter name (automatic)
264
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE LINECODE
The E1 service provider determines the linecode type, whether ami or hdb3 is
required for your E1 circuit.
Note: If ‘ami’ linecode is configured, configure timeslot speed to 56Kbps to ensure ones
density.
E
XAMPLE
The following example sets the line code type for E1 to ami:
ALU(config-controller E1)# linecode ami
The following example sets the line code type for E1 to hdb3:
ALU(config-controller E1)# no linecode
T
O SET A CLOCKSOURCE ON E1
E
XAMPLE
The following example configures the E1 0 clocksource to line:
ALU(config-controller E1)# clocksource line
The following example configures the E1 0 clocksource to internal:
ALU(config-controller E1)# no clocksource
Command (in CCM) Description
linecode {ami|hdb3} This command is used to set a Line
Encoding for the E1 interface.
no linecode The “no” command sets the linecode to
its default.
The default linecode value is HDB3.
Command (in CCM) Description
clocksource {internal|line} This command is entered in the
controller configuration mode to set
clocksource for E1 interface. The
keyword "clocksource" is used to
configure clock signals.
no clocksource The “no” keyword sets the clocksource
to its default.
The default value for clocksource is
internal.
To Next Page
Loading...
Need help?
General
