T1E1 Line Card
Left running head:
Chapter name (automatic)
280
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE FRAMING ON T1
The service provider determines which framing type, either sf or esf is required for
your T1 circuit.
E
XAMPLE
The following example configures frame type as super frame for T1:
ALU(config-controller T1)#framing sf
The following example resets the T1 frame type to esf:
ALU(config-controller T1)# no framing
T
O CONFIGURE LINECODING ON T1
The T1 service provider determines which line-code type, ami, or b8zs, is required
for your T1 circuit.
E
XAMPLE
The following example specifies AMI as the linecode type for a T1 line:
ALU(config-controller T1)# linecode ami
The following example sets b8zs, as the linecode type:
ALU(config-controller T1)# no linecode
Command (in CCM) Description
framing {esf|sf} This command is entered in the
controller configuration mode to
configure framing type.
no framing The “no” command sets the framing to
its default.
The default framing value for T1 is
esf.
Command (in CCM) Description
linecode {ami|b8zs} This command is entered in the
controller configuration mode to
configure the line-code type for a T1 line.
no linecode The “no” command sets the linecoding
value its default.
The default linecoding value is b8zs.
To Next Page
Loading...
Need help?
General
