T1 Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
281
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO CONFIGURE CLOCKSOURCE
E
XAMPLE
The following example configures the T1 0 clocksource for line:
ALU(config-controller T1)# clocksource line
The following example configures the T1 0 clocksource for internal:
ALU(config-controller T1)# no clocksource
T
O CONFIGURE A SERIAL INTERFACE
EXAMPLE
The following example creates an interface at slot 0 and port 0 at group 0:
ALU(config)#interface Serial0/0:0
ALU(config-if Serial0/0:0)#
Command (in CCM) Description
clocksource {internal|line} This command is entered in the
controller configuration mode to set
clocksource for T1 interface. The
keyword "clocksource" is used to
transmit clock signals.
no clocksource The “no” command sets the clocksource
to its default.
The default value for clocksource is
internal.
Command (in CM) Description
interface Serial <slot/
port:channel>
This command is entered in the Interface
configuration mode to configure a serial
interface.
To Next Page
Loading...
Need help?
General
