Alcatel-Lucent OmniAccess 5740 - Page 438

Ethernet OAM (Operations, Administration, and Maintenance)
Left running head:
Chapter name (automatic)
412
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
I
NITIATE ETHERNET OAM PERFORMANCE MANAGEMENT TESTS
TO ENABLE/DISABLE ETHERNET TEST SIGNAL ON A MEP
E
XAMPLE
ALU(config-oam-domain-assoc-mep)# eth-test enable
T
O CONFIGURE TEST PATTERN FOR ETHERNET TEST SIGNAL
EXAMPLE
ALU(config-oam-domain-assoc-mep)# eth-test test-pattern all-
ones crc enable
T
O INITIATE ETHERNET TEST SIGNALLING
EXAMPLE
ALU(config-oam)# eth-cfm eth-test 1111.1111.1111 mep 10
domain 1 association 10 priority 2
Command (in OAM-DA MEP CM) Description
eth-test {enable|disable} This command is used to enable or
disable Ethernet test signal on a MEP.
By default, Ethernet test is disabled.
Command (in OAM-DA MEP CM) Description
eth-test test-pattern {all-
ones|all-zeros} crc
{enable|disable}
This command is used to configure test
pattern for Ethernet test signal on a MEP.
By default, the test pattern is all 0's and
no CRC.
Command (in OAM CM) Description
eth-cfm eth-test <mac-address>
mep <1-8191> domain <0-65535>
association <0-65535>
[{datasize <1-1480>|priority
<0-7>}]
This command is used to initiate an
Ethernet test signal.