Alcatel-Lucent OmniAccess 5740 - Page 439

OAM Configuration on OmniAccess 5740 USG
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
413
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO INITIATE ETHERNET CFM ONE-WAY DELAY TEST
ETH-DM can be used to measure frame delay and frame delay variation. Frame
delay and frame delay variation measurements are performed by sending periodic
frames with ETH-DM information to the peer MEP and receiving frames with ETH-
DM information from the peer MEP during the diagnostic interval. This is achieved
by using 1DM and DMM/DMR messages.
E
XAMPLE
ALU(config-oam)# eth-cfm 1DMtest 1111.1111.1111 mep 10 domain 1
association 10 priority 2
T
O INITIATE ETHERNET CFM TWO-WAY DELAY TEST
EXAMPLE
ALU(config-oam)# eth-cfm 2DMtest 1111.1111.1111 mep 10 domain 1
association 10 priority 2
Command (in OAM CM) Description
eth-cfm 1DMtest <mac-address>
mep <1-8191> domain <0-65535>
association <0-65535>
[priority <0-7>]
This command is used to initiate a ETH-
CFM one-way delay test.
Command (in OAM CM) Description
eth-cfm 2DMtest <mac-address>
mep <1-8191> domain <0-65535>
association <0-65535>
[priority <0-7>]
This command is used to initiate a ETH-
CFM two-way delay test.