Bridging Configuration on PPP/MLPPP/FR/MLFR/HDLC/GigE Interface
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
431
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
BCP SHOW COMMANDS
TO VIEW BRIDGE STATISTICS
EXAMPLE
ALU(config)# show bridge statistics
************BRIDGE STATISTICS************
Bridge Packets input 4244
Bridge Packets output 0
Bridge Packets to IRB 0
Bridge Packets from IRB 0
Bridge Packets stp 4244
Bridge Packets drop 0
Bridge Packets stp blocked 0
Bridge Packets pvstp blocked 0
T
O VIEW BRIDGING STATISTICS ON MLPPP
E
XAMPLE
ALU(config)# show interfaces mlppp 1
mlppp1 is up, line protocol is up
Internet address not set
MTU 1494 bytes, BW 1984 Kbit, DLY 0 usec,
reliability 255/255, txload 0/255, rxload 0/255
Encapsulation mlppp, loopback not set
BCP: Open
IPCP: Stopped
Last input never, output never, output hang never
Last clearing of "show interface" counters never
5 minutes input rate 160 bits/sec, 0 packets/sec
5 minutes output rate 160 bits/sec, 0 packets/sec
16 packets input (2 Control packets, 14 Data packets), 1198 bytes
8 packets output (2 Control packets, 6 Data packets), 678 bytes
0 Small packets dropped, 0 giants received
0 protocol packets dropped, 0 non ppp packets dropped
14 packets bridged, 2 bridge packets dropped
Fragmentation: Fragment Delay 0 ms
0 fragmented, 0 couldn't fragment
0 fragments created, 0x18 sent sequence
Command (in SUM/CM) Description
show bridge statistics This command displays the bridging
statistics on the system.
Command (in SUM/CM/ICM) Description
show interfaces mlppp <1-256> This command displays bridging
statistics on the MLPPP interface.
To Next Page
Loading...
