Make sure that:
• The small end of the small solder sleeve is put on the cable first
• The large end of the large solder sleeve is put on the cable first.
(5) If the splice kit does not have seal inserts and the solder sleeves are the same size:
(a) Put these splice assembly components on Cable A Cable B in this sequence:
• The outer sleeve
• A solder sleeve
• The shield material.
Make sure that the small end of the solder sleeve is put on the cable first.
(b) Put the other solder sleeve on Cable B.
Make sure that the small end of the solder sleeve is put on the cable first.
(6) Put Wires A1 and B1 together.
(7) Put a seal sleeve on the Wire A1 and Wire B1 pair.
(8) If the optional configuration for cable D is not chosen:
(a) Put Wires C1 and D1 together.
(b) Put a seal sleeve on the Wire C1 and Wire D1 pair.
(9) If the optional configuration for cable D is chosen:
(a) Put wires C2 and D2 together.
(b) Put a seal sleeve on the Wire C2 and Wire D2 pair.
ASSEMBLY OF BACS52P SERIES AND D-150-0300 SERIES SHIELDED SPLICE ASSEMBLIES
707, 727-787
STANDARD WIRING PRACTICES MANUAL
20-30-20
Page 107
Jun 15/2021D6-54446
ECCN 9E991 BOEING PROPRIETARY - See title page for details
To Next Page
Loading...
