(8) Put the moving lower die in the ram well.
Make sure that:
• The alignment dot on the front face of the die is on the same side as the ram setscrew.
• The shanks on the moving and the stationary dies are offset from the same surface.
(9) Tighten the ram setscrew.
(10) Close the yoke and install the latch pin.
(11) Slowly close the dies.
Make sure that the dies are correctly aligned.
(12) Complete the cycle to put the ram in the down position.
Make sure that:
• The dies are installed with the alignment marks on the same side of the tool head
• The dies are attached correctly to the tool head
• The latch pin is fully installed in the tool head.
M. Preparation of the Tyco 69066 Hydraulic Crimp Tool
WARNING
DO NOT ACCIDENTLY PRESS THE FOOT PEDAL OR THE HANDLE CONTROL
WHILE THE DIES ARE REMOVED OR INSTALLED. AN INJURY TO PERSONNEL
CAN OCCUR.
WARNING
DO NOT INSTALL DIFFERENT DIES FROM DIFFERENT DIE SETS IN A CRIMP
TOOL HEAD. AN INJURY TO PERSONNEL CAN OCCUR.
ASSEMBLY OF AMP (TYCO) COPALUM, MS25435 AND THOMAS & BETTS ALUMINUM
TERMINALS
707, 727-787
STANDARD WIRING PRACTICES MANUAL
20-30-14
Page 41
Oct 15/2017D6-54446
ECCN 9E991 BOEING PROPRIETARY - See title page for details
To Next Page
Loading...
