(4) If the splice kit does not have seal inserts and has different size solder sleeves, put these
components on Cable A and Cable B in this sequence:
• The outer sleeve
• The small solder sleeve
• The shield material
• The large solder sleeve.
Make sure that:
• The small end of the small solder sleeve is put on the cable first
• The large end of the large solder sleeve is put on the cable first.
(5) If the splice kit does not have seal inserts and the solder sleeves are the same size:
(a) Put these splice assembly components on Cable A and Cable B in this sequence:
• The outer sleeve
• A solder sleeve
• The shield material.
Make sure that the small end of the solder sleeve is put on the cable first.
(b) Put the other solder sleeve on Cable C and Cable D.
Make sure that the small end of the solder sleeve is put on the cable first.
(6) Put Wire A1 and Wire B1 together.
(7) Put a seal sleeve on Wire A1 and Wire B1 pair.
(8) Put Wire A2 and Wire B2 together.
(9) Put a seal sleeve on Wire A2 and Wire B2 pair.
(10) Put Wire C3 and Wire D3 together.
(11) Put a seal sleeve on Wire C3 and Wire D3 pair.
ASSEMBLY OF BACS52T SERIES SHIELDED SPLICE ASSEMBLIES
707, 727-787
STANDARD WIRING PRACTICES MANUAL
20-30-21
Page 62
Oct 15/2020D6-54446
ECCN 9E991 BOEING PROPRIETARY - See title page for details
To Next Page
Loading...
