(a) Put these components on Cable A In this sequence:
• The outer sleeve
• The small solder sleeve
• The shield material
• The large solder sleeve.
Make sure that:
• The small end of the small solder sleeve is put on the cable first
• The large end of the large solder sleeve is put on the cable first.
(b) Put the other seal insert on Cable B, if a build-up sleeve is not specified for the cable.
(c) If the seal insert O.D. is too small for the cable O.D., cut the seal insert along the axis and
wrap the seal insert around the cable.
(3) If the splice kit has seal inserts and same size solder sleeves:
(a) Put these splice assembly components on Cable A in this sequence:
• The outer sleeve
• A seal insert, if a build up sleeve is not specified on the cable
• A solder sleeve
• The shield material.
Make sure that the small end of the solder sleeve is put on the cables first.
(b) Put these splice assembly components on Cable B in this sequence:
• The other seal insert, if a build-up sleeve is not specified for the cable
• The other solder sleeve.
Make sure that the small end of the solder sleeve is put on the cable first.
(c) If the seal insert O.D. is too small for the cable O.D., cut the seal insert along the axis and
wrap the seal insert around the cable.
(4) If the splice kit does not have seal inserts and has different size solder sleeves put these
components on Cable A in this sequence:
• The outer sleeve
• The small solder sleeve
• The shield material
• The large solder sleeve.
Make sure that:
• The small end of the small solder sleeve is put on the cable first
• The large end of the large solder sleeve is put on the cable first.
(5) If the splice kit does not have seal inserts and the solder sleeves are the same size:
(a) Put these splice assembly components on Cable A in this sequence:
• The outer sleeve
• A solder sleeve
ASSEMBLY OF BACS52T SERIES SHIELDED SPLICE ASSEMBLIES
707, 727-787
STANDARD WIRING PRACTICES MANUAL
20-30-21
Page 72
Jun 15/2021D6-54446
ECCN 9E991 BOEING PROPRIETARY - See title page for details
To Next Page
Loading...
