104 Address Table Commands
Syntax
•
port security mode
{
lock
|
max-addresses
}
• no port security mode
•
lock
— Saves the current dynamic MAC addresses associated with the port and disables learning,
relearning and aging.
•
max-addresses
— Deletes the current dynamic MAC addresses associated with the port and learns
up to the maximum number addresses allowed on the port. Relearning and aging are enabled.
Default Configuration
This setting is disabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
There are no user guidelines for this command.
Example
In this example, port security mode is set to dynamic for Ethernet interface 1/7.
port security max
The port security mode Interface Configuration (Ethernet, port-channel) mode command configures
the maximum addresses that can be learned on the port while the port is in port security max-addresses
mode. Use the no form of this command to restore the default configuration.
Syntax
•
port security max
{
max-addr
}
• no port security max
•
max-addr
— Maximum number of addresses that can be learned on the port. Range is 1-128
Default Configuration
This default configuration is 1.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
Console(config)# interface ethernet g7
Console(config-if)# port security mode mac-addresses
5400_CLI.book Page 104 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
