Dell PowerConnect 5424 Command Line Interface Guide

240 iSCSI Commands
Example
The following example displays the iSCSI settings.
show iscsi sessions
The show iscsi sessions Privileged EXEC mode command displays the iSCSI sessions.
Syntax
• show iscsi sessions [ detailed ]
• detailed — Displayed list is detailed when this option is used.
Default Configuration
If not specified, sessions are displayed in short mode (not detailed).
Command Mode
Privileged EXEC mode.
Console # show iscsi
iSCSI enabled
iSCSI vpt is 5, remark
Session aging time: 60 min
Maximum number of connections is 256
--------------------------------------------------
iSCSI targets and TCP ports:
---------------------------
TCP Port Target IP Address Name
860
3260
5000
30001 172.16.1.1 iqn.1993-11.com.disk-
vendor:diskarrays.sn.
45678.tape:sys1.xyz
30033 172.16.1.10
30033 172.16.1.25
5400_CLI.book Page 240 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation