iSCSI Commands 235
iSCSI Commands
iscsi enable
The iscsi enable Global Configuration mode command globally enables iSCSI awareness. Use the
no form of this command to disable iSCSI awareness.
Syntax
• iscsi enable
• no iscsi enable
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
• Until iSCSI VLAN is configured by using
iscsi vlan
command the switch will not assign any
specific VLAN to iSCSI flows.
• When User uses the
no iscsi enable
command, iSCSI resources (TCAM) should be released.
Example
The following example enable iSCSI awareness.
iscsi target port
The iscsi target port Global Configuration mode command configures iTCP port(s), iSCSI targets'
addresses and names. Use the no form of this command to delete iSCSI port/s, target.
Console (config)# iscsi enable
5400_CLI.book Page 235 Wednesday, December 17, 2008 4:33 PM