Dell PowerConnect 5424 Command Line Interface Guide

IGMP Snooping Commands 201
User Guidelines
• There are no user guidelines for this command.
Example
The following example shows IGMP snooping mrouter information.
show ip igmp snooping interface
The show ip igmp snooping interface User EXEC mode command shows IGMP snooping configuration.
Syntax
• show ip igmp snooping interface vlan-id
• vlan_id — VLAN ID value.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode.
User Guidelines
• There are no user guidelines for this command.
Console # show ip igmp snooping mrouter
VLAN Ports
---- ------
2g1
5400_CLI.book Page 201 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation